|
When configuring a Cisco Router for the first time, use the initial configuration routine that runs when you achieve a
console connection during the first boot up.
A console connection is made by using the roll-over cable and connector supplied with your Cisco router.The serial line settings are:
- Baud = 9600
- Data bits = 8
- Stop bits = 1
- Parity = None
- Flow controll = None
If you need specific answers to configuring your Cisco Router, visit the following sites:
http://www.cisco.com/
Cisco's Technical Assistance Center http://cisco.com/cgi-bin/ibld/view.pl?i=support
(Note: this site requires a Cisco support contract to access.)
|
|
